LTE ICIC 提案:R1050507soft frequency reuse HW.doc

上传人:文库蛋蛋多 文档编号:3023543 上传时间:2023-03-08 格式:DOC 页数:6 大小:596KB
返回 下载 相关 举报
LTE ICIC 提案:R1050507soft frequency reuse HW.doc_第1页
第1页 / 共6页
LTE ICIC 提案:R1050507soft frequency reuse HW.doc_第2页
第2页 / 共6页
LTE ICIC 提案:R1050507soft frequency reuse HW.doc_第3页
第3页 / 共6页
LTE ICIC 提案:R1050507soft frequency reuse HW.doc_第4页
第4页 / 共6页
LTE ICIC 提案:R1050507soft frequency reuse HW.doc_第5页
第5页 / 共6页
点击查看更多>>
资源描述

《LTE ICIC 提案:R1050507soft frequency reuse HW.doc》由会员分享,可在线阅读,更多相关《LTE ICIC 提案:R1050507soft frequency reuse HW.doc(6页珍藏版)》请在三一办公上搜索。

1、3GPP TSG RAN WG1 Meeting #41R1-050507Athens, Greece, 9 13 May, 2005Agenda Item:13.2Source:HuaweiTitle:Soft Frequency Reuse Scheme for UTRAN LTEDocument for:Discussion 1 IntroductionThe objective of UTRA evolution study item is to develop a framework for the evolution of the 3GPP radio-access technol

2、ogy towards a high-data-rate, low-latency and packet-optimized radio-access technology 1. The new requirements on higher spectrum efficiency and increased data rate at the cell edge, along with consideration of alternative transmission technologies such as OFDM, open the question of the frequency re

3、use factor in EUTRA.In this contribution we show some benefits of the so-called soft reuse scheme for the application in the EUTRA along with multi-carrier based transmission technologies, such as OFDM for example. The optimum reuse factor at the cell edge is analysed in Section 2. The soft frequenc

4、y reuse scheme, which is characterised by frequency reuse factor 1 in the central region of a cell, and by frequency reuse factor greater than 1 at the outward cell region close to the cell edge, is defined in details in the Section 3. The benefits of soft reuse scheme are pointed out in section 4.

5、Finally, some conclusions are given in Section 5.2 Frequency Reuse Factor Analysis In a multi-carrier telecommunication system, the frequency reuse can be achieved in 2 ways:1. Carrier method: different carriers in different cell, same to traditional frequency reuse method.2. Sub-carrier method: sam

6、e carrier and different sub-carriers in different cell which illustrated in Fig. 1.In a wireless cellular communication system, the signal to interference ratio (SIR) can be generally described as: (1): the received power of the expected user signal: inner cell interference power : other cell interf

7、erence power: white noise powerWe assume that advanced MA scheme or receiver is used, the intra-cell interference is eliminated, and the SIR representation can be simplified as: . (2)In case of flat fading channel, according to the Shannons theorem, the channel capacity is given as: (3)Fig.1 Sub-car

8、rier frequency reuse schemeTab 1 RF Parameters Used in ComputationParameters ValueComputation Equation Carrier Bandwidth W (MHz)20AWhite noise power density(dBm/Hz)-174BReceiver Noise Figure (dB)5CWhite noise power (dBm)-96D=10*log(A)+B+CTx power (dBm)45ECell Radius (km)1.0FPath loss Model (dB)137.3

9、G137.3 + 35.2*log(F)According the above equations and RF parameters, we calculate the SIR and channel capacity at the cell edge. A 27 cell network is used for computations, as shown in Fig. 2. Mobile stations are located at the intersection of 3 adjacent cells which are represented by the red dot. I

10、n the network, the transmitting power of the serving and interfering cell is 45dBm. Fig.2 Network deployment used in the computationThe SIR and cell edge channel capacity variation with the reuse factor are depicted in the following Fig. 3 and Fig.4 respectively.Fig.3 SIR at the cell edge Fig.4 Chan

11、nel Capacity at the cell edgeFrom the above two Figures, some arguments are listed below:1. Smaller the reuse factor corresponds to larger available bandwidth for each cell, and lower signal to interference (SIR) due to co-channel interference. On the contrary, larger reuse factor corresponds to sma

12、ller available bandwidth and higher SIR.2. In the case of reuse factor is 1 or 2, due to the co-channel interference from the adjacent cell, the SIR at cell edge are -4.4dB and -1.1dB respectively, which are very low. This is the reason for a low channel capacity at the cell edge, which are 89Mbps.3

13、. In the case of reuse factor is 3, due to the elimination of co-channel interference from the adjacent cell, there is an obvious improvement in the SIR at the cell edge. The SIR value reaches 5.89dB in the computation example. Although the available bandwidth is 1/3 of the total bandwidth, the gain

14、 in SIR can counteract the loss in the bandwidth; the channel capacity reaches 15Mbps, which is near double of the capacity at the case of reuse factor 1.4. With the increase of reuse factor, the co-channel interference continues to decrease, and so the SIR continues to improve. However, the increme

15、nts of SIR can not counteract the loss in bandwidth, so the channel capacity decreases. 5. In the computation example, the intra-cell interference is not considered. Here, the assumption is that the intra-cell interference can be eliminated by advanced multiple access scheme such as OFDM, MC-CDMA an

16、d advanced receiver algorithm such as frequency domain equalizer, etc. The main noise comes mainly from co-channel interference from other cell and white noise. However, in the traditional CDMA/RAKE receiver system, the premise does not exist. The intra-cell interference is the main contributor of t

17、he noise, so the reuse factor 1 is the optimal choice in that case.6. After the reuse factor exceeds 3, the channel capacity at the cell edge decrease at a relatively slow rate, and remain above the channel capacity of reuse factor 1 and 2. However, higher reuse factor leads to a low co-channel inte

18、rference and high SIR. This means the noise-resistant capability is poor. The unpredictable noise, such as environment noise will result in a sharp decrease in the SIR and channel capacity. Notes: The unpredictable noise is not the thermal noise in euqation (1), so its power is not divided by reuse

19、factor?3 Soft Frequency Reuse SchemeThe analysis of above sections shows that, the inter-cell interference at the cell edge is greatly reduced through frequency reuse, and so improves the channel capacity. When the mobile station is near the antenna of the base station, the received power of the wan

20、ted user signal is strong, and the interference from other cell is weak. So at the inner part of the cell, all the sub-carriers can be used to achieve high data rate communication. The soft frequency reuse scheme is characterised by frequency reuse factor 1 in the central region of a cell, and by fr

21、equency reuse factor greater than 1 at the outward cell region close to the cell edge. An example of soft frequency reuse scheme is illustrated in Fig. 5.Fig.5 Soft frequency reuse scheme in a multi-carrier systemIn the above figure, mobile station 11 and 12 are linked to base station 1, mobile stat

22、ion 21 and 22 are linked to base station 2, and mobile station 31 and 32 are linked to base station 3. Mobile station 11, 21 and 31 are located at the intersection of 3 cells, mobile station 12, 22 and 32 are at the inner part of their respective cells. For the mobile station at the cell edge, diffe

23、rent sub-carriers are allocated to them to avoid the co-channel interference. For the mobile stations near the base station, all the sub-carriers can be allocated to them to achieve high data rate. In this scheme, the frequency reuse factor is 3 for the cell edge and 1 for the inner part of the cell

24、. For the inner part of the cell, through the limitation of the transmission power, some isolated islands are formed and do not interference each other. Fig.6 illustrates numerically the benefits of soft frequency reuse scheme.Fig.6 Cell throughput in soft frequency reuse schemeThe three mobile stat

25、ions are located at the intersection of 3 cells, and 1/3 of the total bandwidth of 20MHz is allocated to each of them. Another 3 mobile stations are located at the position with the distance to their server base station being half of the cell radius, and 2/3 of the total 20MHz bandwidth are assigned

26、 to them. In Fig.6, the horizontal axis represents the transmission power spectrum density ratio of inner cell to the cell-edge. The numerical example shows the following results:1. When the power ratio is 0, the cell edge bit rate is 15.2Mbps, which is equivalent to the case of reuse factor 3.2. Wh

27、en the power ratio increase, the inner cell bit rate increases, and the cell edge bit rate decrease due to the increase of co-channel interference. However, the total throughput of the cell increases. 3. When the power ratio reaches to 1, the cell-edge bit rate decreases to 2.96Mbps. This result cor

28、responds to 1/3 of the cell edge bit rate at reuse factor 1. Because in this case the interference condition at the cell edge is same to reuse factor 1 and the bandwidth is 1/3 of the total bandwidth. Notes: thermal noise is 1/3 of total bandwidth noise. Keep cell edge MSs power unchanged, inter-cel

29、l interference is the same as reuse factor 1 and 1/3 of the total bandwidth but MS at central region. So re-evaluating the bit rate result is necessary.Through the adjustment of power spectrum density ratio from 0 to 1, the frequency reuse factor changes from 3 to 1 gradually. This is the reason why

30、 scheme can be called soft frequency reuse scheme. 4 Benefits of soft frequency reuse schemeThe benefits of the soft frequency reuse scheme include the following: Improved bit rate at cell edge; High bit rate at the cell centre; Avoid interference at the cell edge, so the following procedure is easi

31、er:u Channel estimationu Synchronisationu Cell selection and reselection Gives coordination for the scheduling in different NodeBs and make the algorithm more stable and efficient; No need for the resource coordination of different NodeBs in RNC(or corresponding node above Node B) in the fixed resou

32、rce allocation method; If dynamic resource allocation algorithm are used in the node above Node B, load balancing in different cells can be achieved; No need for the communication of different NodeBs;5 ConclusionThe combination of the frequency reuse factor 1 in the inner part of a cell, and the fre

33、quency reuse factor 3 at the outer ring of the cell, called soft frequency reuse scheme, is shown to improve both spectrum efficiency and the cell edge data rate in a EUTRA system based on multi-carrier transmission technology. It seems that this principle should be taken into account at the early s

34、tage of the EUTRA multiple access design, for both the UL and DL.Notes: if fixed resource allocation utilized, SFR will be a moderate method at the early stage of LTE.6 References1 Proposed Study Item on Evolved UTRA and UTRAN, RP-040461.2 M.Sternad, T.Ottoson, A. Ahln and A.Svensson, “Attaining both Coverage and High Spectral Efficiency with Adaptive OFDM Downlinks”, IEEE Vehicular Technology Conference VTC2003-Fall, Orlando, Florida, Oct. 2003

展开阅读全文
相关资源
猜你喜欢
相关搜索
资源标签

当前位置:首页 > 教育教学 > 成人教育


备案号:宁ICP备20000045号-2

经营许可证:宁B2-20210002

宁公网安备 64010402000987号