《cimatronE倒圆角.doc》由会员分享,可在线阅读,更多相关《cimatronE倒圆角.doc(10页珍藏版)》请在三一办公上搜索。
1、Round - optionsTable of contentsDescription1Round options2Cimatron E WorkshopRound - optionsPage 9DescriptionIn this exercise you will learn the new options in the Solid Round function Round options1Receive and open the file: round-t.dtf2Try to get the following result:See explanation in the next st
2、eps 3Select the option Round - Face Face FaceSelect the first and the second faces as shown in the picture.Try the following:1) Trim FacesRadius Value = 12Extension on2)Keep OriginalRadius Value = 12Extension offChange to WF mode and press the preview button, to view the differing results. 4Change t
3、he option Extension off to on.Approve these parameters 5Select the option Round Face Edge faceSelect the Edge and the face as shown in the pictureRadius = 27.Approve these parameters 6Select the option Round, and select the edge indicated by the arrow.R = 38.In the options dialog check the Hold opti
4、on. Change the option Hold to Extend. Select preview.Note the different face and also the extension indicated by the arrow.Approve the round with the Extend option. 7Apply a round on the edge indicated by the arrow.In the options dialog, ensure that the Add Smooth edges is checked.Approve the round.
5、8Insert to one feature before the last round.Apply a round on the corner indicated by the arrow.Change the options from Rolling Ball to Blend.Approve these parameters 9Jump to the last featureNote that during regeneration, the smooth edge of the new round was added to the current round. 10Undo the last two operationsEdit the last Round operationUncheck the option: Add Smooth EdgesInsert to one operation before the latest round. Apply exactly the same round as before.Jump to endThis time during regeneration the smooth edge of the inserted round was not added to the current round.