《毕业设计(论文)外文参考资料及译文自动化操作的大型电力系统广大范围的市场供需和设备的运行状况.doc》由会员分享，可在线阅读，更多相关《毕业设计(论文)外文参考资料及译文自动化操作的大型电力系统广大范围的市场供需和设备的运行状况.doc（21页珍藏版）》请在三一办公上搜索。
1、毕 业 设 计（论 文）外 文 参 考 资 料 及 译 文译文题目： 自动化操作的大型电力系统广大范围 的市场供需和设备的运行状况 学生姓名：朱礼梅 学号： 0921410039 专业： M09电气工程及其自动化 所在学院： 金陵科技学院 指导教师： 陈丽娟 职称： 2011年 3月 19 日说明：要求学生结合毕业设计（论文）课题参阅一篇以上的外文资料，并翻译至少一万印刷符（或译出3千汉字）以上的译文。译文原则上要求打印（如手写，一律用400字方格稿纸书写），连同学校提供的统一封面及英文原文装订，于毕业设计（论文）工作开始后2周内完成，作为成绩考核的一部分。AUTOMATING OPERATI
2、ON OF LARGE ELECTRIC POWER SYSTEMS OVER BROAD RANGES OF SUPPLY/DEMAND AND EQUIPMENT STATUSAbstract One of the ultimate challenges in operating todays electric power grids is in designing automation for managing the system as demand varies over broad ranges and the status of major equipment changes.
3、These changes are often hard to predict and it is, therefore, fundamentally impossible to design for the worst case scenarios; such scenarios are not known due to the very combinatorial nature of the problem. One possible way forward is to pursue automation for facilitating systems adjustments as th
4、e conditions vary. In this chapter we propose an extension of todays hierarchical control of electric power grids as one direction toward such automation. The approach is strongly motivated by the recognition that it has become insufficient to rely solely on operators decisions; instead, more on-lin
5、e information gathering and active decision making at various layers of the grid are needed. The proposed generalization is introduced by relaxing some critical assumptions underlying current operating practices, and by deriving layers of models so that each model can capture the events and phenomen
6、a in the power grid at the spatial and temporal scales that are appropriate for each level of decision. These models are used for quasi-stationary state estimation and automated control for the system to adjust smoothly to on-going changes. This is in sharp contrast to todays approach in which autom
7、ation is only used during normal operation, while during abnormal conditions major decisions are made by the humans. The resulting layered-architecture should reduce the complexity of the problem significantly. More important, it should provide the decision makers at each layer with the most relevan
8、t dynamic information that is needed for their own decision level, and at the same time provide the information necessary for the decision makers to respond and adAPPLIED MATHEMATICS FOR POWER SYSTEMS just to the overall system objectives. The layered models form a basis for an information technolog
9、y (IT) infrastructure that can be proven to ensure pre-specified performance at various layers and in the system as a whole. An important observation is that when the assumptions typically made in todays system control are met, the proposed control generalization closely resembles current Supervisor
10、y Control and Data Acquisition (SCADA) and operating practices. In this sense, the approach is a natural outgrowth of what is already in place and should be considered for ensuring reliable and efficient operation over the broad ranges of conditions and equipment status. Keywords: IT infrastructure,
11、 multi-layered electric power system models, quasistationary estimation, quasi-stationary electric power systems control, large-scale computations.1. IntroductionPossibly one of the biggest causes of insecure and inefficient operation of todays electric power systems comes from a sub-optimal use of
12、available resources because of hard-to-predict demand variations and equipment failures. Current operating practices in dealing with both types of uncertainties have been mainly preventive and off-line, without resorting to automated responses to the events and uncertainties. The system has been aut
13、omated only to respond to relatively small demand fluctuations around historic patterns. We suggest here that this is one of the major distinctions between what it is and what it might be in the future electric power systems. These systems must become more automated over wide ranges of supply/demand
14、 patterns and equipment status. While the communications and control hardware are readily available, it is essential to pursue this inevitable automation based on systematic modeling, estimation, and control. However, moving toward more automation could defeat its own purpose unless an IT infrastruc
15、ture is in place to facilitate formation and coupling of sub-networks within the grid as they define sub-objectives according to their own needs and the changing system-wide conditions. Moreover, depending on particular organizational industry structures in place, the nature of complexity of this au
16、tomation varies significantly. At least three structures are of direct interest here: The partitioning of the large electric power grid is given a priori. The main problem here is to introduce an IT infrastructure in support of monitoring and control for providing pre-cursors of extreme conditions,
17、and to adjust available resources so that the system is Automating Operation of Large Electric Power Systems 107 adapting smoothly as the operating conditions and equipment status vary. The major portion in this chapter concerns this problem. A more futuristic problem of automation is the one in whi
18、ch the boundaries of sub-networks are allowed to evolve according to their distributed sub-objectives. The main problem here is to introduce an IT infrastructure for facilitating both distributed decision making by these sub-networks and, at the same time, provide dynamic coupling with the other sub
19、-networks so that performance objectives are met at several higher layers of the industry organization. w Finally, the most complex problem of automation is the one in which economic and regulatory and organizational signals are modeled as endogenous together with the physical and IT infrastructures
20、. This is the problem of long-term evolution of the electric power grid as driven by regulatory, economic, and technological signals. The IT infrastructure here, in contrast with the previous two, is heterogeneous and spans broad range of time horizons and system details. The starting issue for all
21、three cases is the fact that the overall network complexity is outside of humans ability to master at the right time and the right level of detail necessary for best decision making. The boundaries between automation and human decision making are different in the three cases above. In this chapter w
22、e conceptualize an approach to the IT infrastructure for the first case. In our view, this automation for enhanced performance over a broad range of supply/demand patterns and equipment status is critical for avoiding unexpected system-wide failures such as the August 14, 2003 Northeast US blackout.
23、 In the last part of this chapter we provide ideas for extendingour proposed approach to the other two cases. In this chapter we explore fundamentals of possible next generation automation for managing electric power systems over a broad range of demand/supply and equipment status. The approach buil
24、ds upon todays operating practices by conceptualizing sufficiently adaptive models with respect to time and space needed to capture relevant phenomena even when critical assumptions under which todays control is designed fail to hold. These models are grouped according to: (1) the type of operating
25、problems they capture; and (2) rigorous temporal- and spatialmodel reductions of the initially very large models for quasi-stationary estimation of the changing conditions and for the regulation of the setpoints of all available controllers according to the information provided through the estimatio
26、n. Based on these models, a multi-layered multirate IT infrastructure is proposed in support of protocols for (1) auto108 APPLIED MATHEMATICS FOR POWER SYSTEMS mated estimation of on-going changes in operating ranges and equipment status using carefully placed sensors and communications equipment; (
27、2) automated multi-layered communication of state-estimation results to the controllers; and (3) automated control logic adjustments based on the provided information. A multi-layered modeling,estimation and control approach proposed lends itself to choosing the type of data to be measured, rate at
28、which the information needs to be processed and locations for measurements. At present there is no systematic methodology for this purpose. The operators do not know what is happening and are not able to make informed decisions when the system finds itself outside the operating ranges previously sim
29、ulated and/or experienced. This chapter is organized as follows. In Section 2 we briefly review todays hierarchical control and critical assumptions. We identify the challenges in this design when these critical assumptions do not hold.To suggest how one might go about relaxing these critical assump
30、tions, we take a step back in Sections 3 and 4 to review the basic structure of the electric power system dynamics. Based on this review, we introduce in Section 5 a conceptual flow chart for model simplifications when the system conditions vary significantly. It is suggested that it is possible to
31、develop a family of models whose granularity varies with space and time, and which can be used according to the systematic logic in a proposed flowchart for monitoring the system and controlling reliably and efficiently over a very broad range of conditions. 2. Electric Power Grids as Complex Networ
32、k SystemsWe begin by emphasizing the network system nature of electric power grids. Inputs into these network systems are the demand and supply at the nodes. These inputs are served by a vast, complex network that enables the delivery of supply and demand among users and suppliers. The delivery is i
33、n terms of power flowing through the network branches. The flows are, in turn, subject to the network constraints. While the electric power grids generally provide reliable and high quality of electricity service to the end users, the system from time to time experiences extreme stress and blacks ou
34、t. It was recognized several decades ago that in order to avoid such blackouts more coordination Automating Operation of Large Electric Power Systems 109 and on-line monitoring would be needed. Consequently, the field of electric power systems engineering (EPSE) has emerged I. The industry has estab
35、lished control centers, each utility and/or a pool of utilities has these, and they support todays hierarchical monitoring and control of the grid. More recently, there has been an additional trend to operate the system outside the ranges for which the network was designed as a result of increased t
36、endencies to purchase the least expensive power. Competitive provision of electricity has in effect revived the technical question concerning optimization for efficiency in using available resources to supply customers. We show in what follows how our proposed automation would help optimize system-w
37、ide resources through on-line control and get away with all together less expensive stand-by capacity. However, while particular elements of the needed automation are known and have been implemented, there have been no systematic frameworks for ensuring a pre-specified performance in the complex net
38、work systems of interest here. This situation is a result of many factors, including: (1) the evolution and operation of these systems; (2) an overwhelming complexity of the problem as a whole; (3) historical lack of fast reliable monitoring and critical information collection programs, as well as a
39、 lack of communications, control, and computer methods for systems of this complexity; and (4) lack of financial incentives to encourage investments in their computer-aided on-line management. The important consequence of this situation is that these real-life networks require systematic integration
40、 of monitoring, computing, and control for improved performance. Without such integration, which would facilitate timely use of on-line critical information, managing these systems is simply too complex and leads to complex operating failures, such as blackouts in electric power grids. While specifi
41、c technologies are beginning to be available for effective on-line gathering of real-time data in such systems and the case for their use is being made 2, it remains critically important to develop methodologies for differentiating between the information necessary to make decisions in order to prev
42、ent undesired performance, on one side, and excessive data gathering, on the other. Such methodologies are not available at present, and this creates a major obstacle to enhancing the performance of electric power grids.2.1 Assumptions underlying todays operat ionof hierarchical systemsComplex power
43、 grids are currently operated as hierarchical systems under strong assumptions concerning temporal and spatial separation. Both temporal and spatial simplifications are fundamentally based on APPLIED MATHEMATICS FOR POWER SYSTEMS weak interconnections between the sub-networks potentially achieved th
44、rough the network design. Consequently, the supporting models for sub-networks and the network as a whole exhibit general properties of monotone dynamic systems 131. At the equilibrium, monotone systems decrease the magnitude of their state response when the magnitude of the disturbance increases. F
45、or example, when electric demand increases, voltage decreases. This must be accounted for when designing the controllers. Controllers then need to have gains that decrease the demand in order to bring voltage up. Temporal separation in hierarchical network systems is further induced by: (1) the oper
46、ation of fast controllers to stabilize the system dynamics by controlling the local outputs of the individual components; and (2) slower adjustments of the setpoints of these controllers for each sub-network to achieve stationary performance. Further adjustments of the stationary interactions betwee
47、n the sub-networks are made through off-line agreements and with no on-line information about the equipment status outside ones own sub-network 3. The class of monotone systems lends itself to many convenient simplifications of the monitoring and control logic, as well as to the supporting computer
48、algorithms. To start with, monotone systems are effectively controlled in a distributed way, because the effects of each disturbance can be compensated locally for the operating conditions for which the network design is done 4. In addition, no qualitative change in their logic is needed to ensure s
49、tabilization as the operating conditions vary, as long as their system response remains monotone. That is, as long as a linearized matrix of such system preserves the Metzler-matrix properties over the range of operating conditions of interest, at least the sign in the controllers logic is correct, and the system is stabiliz
